X-Wrist band menu

Explore the band menu

Robert Williams avatar
Written by Robert Williams
Updated over a week ago

Depending on the X-Wrist band model you have, we have a selection of band display themes that you can pick from by navigating to "Dashboard""Explore""Settings""Band settings" and then scrolling down and selecting the theme you prefer by clicking on it.

Note that the band must be connected to the app in order for the band settings to appear in your user settings.

Pressing once on the bracelet button takes you to your sport stats.

For all this to be accurate please make sure the data in your user profile and band settings are correct.

  1. "Dashboard" → "Explore" → "Settings" → "User Profile" (age, weight & height)

  2. "Dashboard" →Explore → "Settings"→ "Band Settings" (left or right hand, blood pressure range and skin color)

The band measures skin temperature automatically at the preset time you set in your User Profile or on demand, when you press the button for 4 seconds.

The band measures your heart rate automatically at the preset time you set in your User Profile or on demand, when you press the button for 4 seconds.

The band measures your blood pressure automatically at the preset time you set in your User Profile or on demand, when you press the button for 4 seconds.

You can measure the ECG inside the app or directly on the band.

For this measurements to be accurate please make sure the data in your user profile and band settings are correct.

Press the metal button on the band and keep it pressed.

Keep the finger on the band metal button until the small red loading bar finishes.

Open the app and go directly in the ECG menu from the dashboard and your ECG data will be synced automatically.

The band measures the level of oxygen in your blood automatically at the preset time you set in your User Profile or on demand, when you press the button for 4 seconds.

The band measures the breathing rate automatically at the preset time you set in your User Profile or on demand, when you press the button for 4 seconds. .

You can start a workout from the band.

Just press the main button for 3 seconds and choose the desired workout type then press again to start it.

After you finish the workout press again to finish.

The application will register the workout automatically.

Back button

You can press the back button to go back to the band's previous menu.

The band automatically registers sleep.

The band can be synced with your phone messages.

To enable this feature go to:

"Explore" → "Settings"→ "Band settings" and check that the

app push notifications are ON.

The band will then vibrate when there is a new message according to your preset and will display part of it on the screen.

You can read your messages inside the band as well.

The Setup screen is where you can:

  1. Take a remote picture with your band using your phone camera.

  2. Make the display horizontal.

  3. Set the brightness of the display (the brightness automatically gets to lower setting when your battery is low).

  4. Reset the band to the original state (this will remove all your data stored in the band for the past couple of days).

  5. Shut the band down (you can start it again by pressing the button for 4 seconds).

  6. Go back to the previous menu.

Depending on the version of the band you own, you might have the weather display.

This data is extracted from AccuWeather based on your location (location in your phone settings must always be on for this).

Did this answer your question?